PurePine Radiata and Decorative Profiles

Mouldings are available in fingerjointed radiata, radiata clears, untreated/H3.1 treated, unprimed/primed, white

Fingerjointed mouldings are manufactured in 5.4m lengths, door jambs in 4.2m lengths.  Preprimed treated weatherboards and fascia in 6.0m lengths

Clear radiata mouldings or profiles are supplied in random lengths only

IMPORTANT NOTICE TO ALL OUR CUSTOMERS

All our product is supplied kiln dried to an average 12% moisture content at the time of dispatch.  Merchants and end users must ensure that care is taken to maintain the product in a dry environment at all times.  Moisture uptake is easily detected by swelling between the joints in finger jointing and raised grain in finger jointing and clear profiles.

We do not warranty product that has become wet or damp for any reason, and is showing defects to the finished surface as described above.

A dry storage environment is also required for treated preprimed product.  Primer coats are not designed as a sealer coat but simply as a holding coat. 

So remember - always store all PurePine Radiata Decorative Profiles out of the weather!  Always store well supported either vertical or horizontal, and keep off the ground or floor.

GENERAL INFORMATION

1. Mouldings are available in fingerjointed radiata and radiata clears
2. Fingerjointed mouldings are 5.4m lengths. Pre-primed weatherboards and fascias are 6.0m
   lengths.
3. We accept with pleasure orders and enquiries for non-standard profiles. Such orders and
   enquiries will be by quotation only and cannot be cancelled or returned once the order is
   confirmed.
4. All radiata and fingerjointed profiles are available in H3.1 (treated) specification if required.
5. Always store PurePine profiles out of the weather. This includes pre-primed products. Always store well supported either vertical or horizontal and keep off the ground or the floor. Always handle with care.
6. All prices are subject to change without prior warning.
   Mouldings are available in fingerjointed radiata and radiata clears.

For Bundle Specifications please refer to the Ebook of NZ mouldings

SPECIFIC INFORMATION

• Kiln dried timber will be dried to an average of 12% moisture content by the time of dispatch.
  However, care must be taken when product is in merchants care or on site, that the product
  remains so.

• Panelling profiles require certain fixing techniques to ensure durability.
  - It is important that the following steps be taken to avoid movement of product:
  1. Product must be stored indoors and protected from direct sunlight.
  2. Seal all around before fixing.
  3. Fix by face nailing using adequate nails and glue to all fixing surfaces. (Secret nailing may
  not be sufficient to stop all movement of product).
  4. Stain, polyurethane or paint.

• PurePine will provide whatever product the merchant specifies. However, no liability will be incorrectly specified products

PUREPINE TREATED AND PREPRIMED PRODUCTS

PurePine treated and preprimed products are produced with a high level of care and expertise.
Our aim is to always be in the forefront with technology. We have installed the latest high tech paint
line which provides an outstanding finish.

PurePine uses 100% acrylic paint and PUR glue from Switzerland to ensure that we use only the most
environmentally friendly products. This improves the health of our staff and reduces risk of exposure
to harmful substances to our customers. We are the first in NZ to be approved to treat H3.1 using
water-born methods over solvent based treatments.

We apply a two coat system on all our preprimed products, so no additional primer or undercoat will
be required. Before the second coat of primer is applied, each board passes through a denibber which
smoothes all surfaces and creates a high quality surface finish.